A heavy-duty steel wall-mount bracket that securely supports two slim whole-house housings for a 2-stage system — keeping cartridges aligned and stress off your plumbing.

What it does

The MyWaterClub Dual Mounting Bracket carries the weight of your dual-stage whole-house filtration system so your inlet and outlet plumbing doesn’t have to. Two slim 10″×2.5″ housings bolt into the bracket and the bracket bolts to the wall — giving you a rock-solid, permanent installation.

Beyond simply holding the housings up, the bracket keeps them parallel and evenly spaced so cartridge changes are quick and clean, and it prevents pipe fatigue over time by taking the load off your compression fittings and unions. Ideal for basements, garages, utility rooms, or any mechanical area where you want the install to look clean and stay put.

Key benefits

• ✓Heavy-duty metal construction — built to hold the weight of two water-filled housings
• ✓Keeps housings parallel and evenly spaced for easier cartridge changes
• ✓Takes the load off inlet/outlet plumbing — reduces stress on fittings and unions
• ✓Clean, professional install — suitable for residential and light commercial use
• ✓Pre-drilled mounting holes for straightforward wall installation
• ✓Matches all MyWaterClub 2-stage slim whole-house systems (3/4″ port)

Specifications

Compatibility

Fits these MyWaterClub systems

Good to know before you buy

• Mounting hardware is not included. Choose screws and wall anchors appropriate for your wall type (wood stud, drywall, masonry, etc.).
• Anchor the bracket into a stud or solid backing whenever possible — two water-filled housings can weigh 15–20 lbs, and toggle-only mounts loosen over time.
• Leave clearance below the housings equal to the cartridge length (about 12″) so you can drop the sumps for filter changes without hitting the floor or a shelf.
• For 3-stage systems, use a triple-slot bracket — this one carries two housings only.
• Professional installation recommended if you’re cutting into your main water line.