Description
Description
The PureT TFCKM-1810-50 is a 50 GPD thin-film composite (TFC) reverse osmosis membrane for Sears Kenmore UltraFilter and Whirlpool WHER reverse osmosis systems. These systems use a shorter 1.8″ × 10″ membrane that standard 12″ membranes don’t fit. This membrane is made to that size, so it drops into your existing housing and brings your system back to full output and rejection without a dealer visit.
What this membrane does
The membrane is the heart of a reverse osmosis system. Water is pushed through a semi-permeable thin-film layer that lets water molecules pass and sends dissolved solids, salts and metals to the drain. The carbon pre-filters before it remove chlorine and sediment; the post-filter after it polishes taste. Over 2–3 years the membrane slowly loses output and rejection, and replacing it brings the system back to like-new performance.
Key benefits
- Made in the 1.8″ × 10″ size used by Kenmore UltraFilter and Whirlpool WHER12 / WHER18 systems
- 50 GPD output; also upgrades systems that came with a 36 GPD membrane
- Thin-film composite membrane material made in USA
- Factory-sealed and dry-packed for long shelf life
- Drop-in replacement, no tools or plumbing changes
- Costs a fraction of discontinued OEM Kenmore and Whirlpool membranes
Specifications
| Attribute | Value |
|---|---|
| Model | PureT TFCKM-1810-50 |
| SKU | MEM-1810-50-KM |
| Rated output | 50 GPD at 50 psi (~2.1 gal/hr)* |
| Membrane type | Polyamide thin-film composite (TFC) |
| Water type | Tap water (municipal or well) |
| Size | 1.8″ × 10″ |
| Cross-reference | TW30-1810-50 size; Kenmore 7267970, 37233557; Whirlpool 7266186† |
| Replacement interval | 2–3 years, or when product-water TDS rises |
| Pre-treatment | Carbon pre-filters required (chlorine removal) |
What a TFC membrane helps reduce
| Category | Examples | Average reduction* |
|---|---|---|
| Total Dissolved Solids | Overall TDS reading | 90–98% |
| Fluoride | Fluoride | 85–95% |
| Heavy metals | Lead, copper, chromium, cadmium | 90–98% |
| Nitrates/nitrites | Nitrate, nitrite | 80–95% |
| Dissolved salts and minerals | Sodium, calcium, sulfate, chloride | 90–98% |
*Typical ranges for residential TFC membranes. Not a certified claim for each unit. Actual results depend on water pressure, temperature, TDS and pre-filter condition.
About bacteria and microorganisms: this membrane is not sold as a microbiological purifier. Do not use it with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Which membrane do I need?
| Your system | Size | Output | Membrane |
|---|---|---|---|
| Kenmore UltraFilter 150/300/350/500/550, Whirlpool WHER12 / WHER18 | 1.8″ × 10″ | ~2.1 gal/hr | MEM-1810-50-KM (this membrane) |
| RainSoft UF50T / UF50N | 1.8″ × 10″ | ~2.1 gal/hr | MEM-1810-50-RS |
| Standard under-sink RO, 1812 housing | 1812 | ~2.1 gal/hr | MEM-1812-50-U or TW-1812-50 |
| Watts Premier WP-4V, WP-5 | 1.8″ × 11-5/8″ | ~2.1 gal/hr | MEM-1812-50-WP |
| Culligan AC-30 / AC-15 | 1.85″ × 12″ | ~2.1 gal/hr | MEM-1812-50-CU |
Good to know before you buy
What “50 GPD” means. 50 gallons per day is the lab rating at 50 psi, about 2.1 gallons per hour. At typical home pressure and cooler water, expect less.*
Upgrading from a 36 GPD membrane? UltraFilter 150, 300 and 350 systems originally shipped with a 36 GPD membrane. This 50 GPD membrane fits the same housing. If your system has a separate drain flow restrictor sized for 36 GPD, replace it with a 50 GPD restrictor for best results.
Pre-filters protect the membrane. Chlorine destroys TFC membranes. Replace your carbon pre-filters on schedule, ideally at the same time as the membrane.
Replace the O-rings if they look worn. Older Kenmore and Whirlpool housings rely on O-ring seals. A flattened or cracked O-ring can leak or let water bypass the membrane.
Replacing your membrane
- Turn off the cold-water feed to the RO system and close the tank valve.
- Open the RO faucet to release pressure.
- Unscrew the membrane housing (or its cap) following your system’s manual.
- Pull out the old membrane. Note which way it faces.
- Insert the new membrane in the same direction and push it firmly into place.
- Reassemble the housing, turn the water back on, and check for leaks.
- Let the tank fill, then drain it completely. Repeat once and discard the first two tanks.
Compatible systems & replacement membranes
RO systems it fits†
| Brand | System | Model number |
|---|---|---|
| Sears Kenmore | UltraFilter 500 | 625.384750 |
| Sears Kenmore | UltraFilter 550 | 625.385750 |
| Sears Kenmore | UltraFilter 350 | 625.385720 |
| Sears Kenmore | UltraFilter 300 | 625.384720 |
| Sears Kenmore | UltraFilter 150 | 625.385700 |
| Whirlpool | WHER18 | WHER18 |
| Whirlpool | WHER12 | WHER12 |
| EcoWater | Versions of the systems above | Check membrane size: 1.8″ × 10″ |
Replaces these membranes†
| Brand | Part number | Output |
|---|---|---|
| Kenmore | 7267970 | 50 GPD |
| Kenmore | 37233557 | 50 GPD |
| Whirlpool | 7266186 | 50 GPD |
| Kenmore / Whirlpool | 7267962, 7264223 | 36 GPD (upgrade to 50 GPD) |
| FilmTec size | TW30-1810-50, TW30-1810-36 | 50 / 36 GPD |
Not compatible with
- Whirlpool WHER25 and Kenmore UltraFilter 450 systems that use the WHEERM quick-change canister membrane
- Standard under-sink RO systems with a 12″ (1812) membrane housing
- RainSoft systems (use MEM-1810-50-RS)
Check before you order: remove your old membrane and measure it. It should be about 1.8″ wide and 10″ long, a loose membrane (not a sealed canister). If yours is a 12″ membrane or a twist-on canister, this is not the right part. Not sure? Send us a photo of your system’s model label or your old membrane and we’ll confirm the fit.
Fit questions
Will it fit my Kenmore UltraFilter 500?
Yes. The UltraFilter 500 (625.384750) uses a 1.8″ × 10″ 50 GPD membrane, the same size as this one.
Does it fit the Whirlpool WHER18 or WHER12?
Yes. Both use the 1.8″ × 10″ membrane housing.
My system came with a 36 GPD membrane. Can I use this 50 GPD one?
Yes, it fits the same housing and makes more water. For best results, match the drain flow restrictor to 50 GPD if your system has one.
Does it fit the Whirlpool WHER25?
No. The WHER25 uses a twist-on canister membrane (WHEERM), not a loose 10″ membrane.
Is it the same as the RainSoft membrane?
Same diameter and length, but sold for a different system. RainSoft owners should choose MEM-1810-50-RS.
*Rated output, reduction ranges and compatibility are based on manufacturer and industry data; real-world output is usually lower than the rating.
†Sears, Kenmore, UltraFilter, Whirlpool, EcoWater, RainSoft and FilmTec are trademarks of their respective owners. Brand names and part numbers are used only to identify compatible systems. My Water Club is not affiliated with or endorsed by any of these companies. This is a compatible replacement membrane, not an OEM part. Using a non-OEM part may affect your system manufacturer’s warranty.



Reviews
There are no reviews yet.