SKU: TW30-CAC-50 Category: Brand:

Culligan AC-30 / AC-15 Compatible 50 GPD RO Membrane, 1.85″ × 12″ TFC (PureT TW30-CAC-50)

$42.99

Culligan Aqua-Cleer AC-30 / AC-15 compatible stage 3 membrane
50 GPD thin-film composite (TFC), 1.85″ × 12″
Helps reduce TDS, fluoride, nitrates, heavy metals
Drop-in replacement, 2–3 year life
Install after sediment and carbon pre-filters

Only 2 left in stock

Description

Description

The PureT TW30-CAC-50 is a 50 GPD thin-film composite (TFC) reverse osmosis membrane made for Culligan Aqua-Cleer AC-30 and AC-15 drinking water systems. It replaces the stage 3 membrane in these systems, so you can restore full output and rejection yourself instead of booking a dealer service call.

Rating50 GPD*
Size1.85″ × 12″
TypeTFC, tap water
Life2–3 years
FitsCulligan AC-30, AC-15†

What this membrane does

The membrane is the heart of a reverse osmosis system. Water is pushed through a semi-permeable thin-film layer that lets water molecules pass and sends dissolved solids, salts and metals to the drain. The pre-filters before it remove sediment and chlorine; the post-filter after it polishes taste. Over 2–3 years the membrane slowly loses output and rejection, and replacing it brings the system back to like-new performance.

Key benefits

  • Sized for the stage 3 membrane in Culligan AC-30 and AC-15 systems
  • 50 GPD thin-film composite membrane
  • Costs far less than a dealer-installed Culligan membrane
  • Factory-sealed and dry-packed for long shelf life
  • Drop-in replacement, no tools or plumbing changes

Specifications

Attribute Value
Model PureT TW30-CAC-50
SKU MEM-1812-50-CU
Rated output 50 GPD (~2.1 gal/hr)*
Membrane type Polyamide thin-film composite (TFC)
Water type Tap water (municipal or well)
Size 1.85″ O.D. × 12″ L
System stage Stage 3 (RO membrane)
Replacement interval 2–3 years, or when product-water TDS rises
Pre-treatment Sediment and carbon pre-filters required (chlorine removal)

What a TFC membrane helps reduce

Category Examples Average reduction*
Total Dissolved Solids Overall TDS reading 90–98%
Fluoride Fluoride 85–95%
Heavy metals Lead, copper, chromium, cadmium 90–98%
Nitrates/nitrites Nitrate, nitrite 80–95%
Dissolved salts and minerals Sodium, calcium, sulfate, chloride 90–98%

*Typical ranges for residential TFC membranes. Not a certified claim for each unit. Actual results depend on water pressure, temperature, TDS and pre-filter condition.

About bacteria and microorganisms: this membrane is not sold as a microbiological purifier. Do not use it with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Which membrane do I need?

Your system Size Output Membrane
Culligan Aqua-Cleer AC-30 / AC-15 1.85″ × 12″ ~2.1 gal/hr MEM-1812-50-CU (this membrane)
Standard under-sink RO, 1812 housing 1812 ~2.1 gal/hr MEM-1812-50-U or TW-1812-50
Watts Premier WP-4V, WP-5 1.8″ × 11-5/8″ ~2.1 gal/hr MEM-1812-50-WP
Kenmore UltraFilter, Whirlpool WHER12/18 1.8″ × 10″ ~2.1 gal/hr MEM-1810-50-KM
RainSoft UF50T / UF50N 1.8″ × 10″ ~2.1 gal/hr MEM-1810-50-RS

Good to know before you buy

What “50 GPD” means. 50 gallons per day is the lab rating at standard test conditions, about 2.1 gallons per hour. At typical home pressure and cooler water, expect less.*

Pre-filters protect the membrane. Chlorine destroys TFC membranes. Replace your Culligan sediment and carbon cartridges on schedule, ideally at the same time as the membrane.

Dealer-serviced systems. Many Culligan systems are leased or under a dealer service plan. If yours is, check your agreement before replacing parts yourself.

Replacing your membrane

  1. Turn off the cold-water feed to the RO system and close the tank valve.
  2. Open the RO faucet to release pressure.
  3. Open the stage 3 membrane housing following your Culligan manual.
  4. Pull out the old membrane. Note which way it faces.
  5. Insert the new membrane in the same direction and push it firmly into place.
  6. Close the housing, turn the water back on, and check for leaks.
  7. Let the tank fill, then drain it completely. Repeat once and discard the first two tanks.

Compatible systems & replacement membranes

RO systems it fits†

Brand System Membrane stage
Culligan Aqua-Cleer AC-30 Stage 3
Culligan Aqua-Cleer AC-15 Stage 3

Other Culligan systems that use the same AC-series 50 GPD membrane (such as AC-50 or H-83) may also fit. Compare your old membrane’s size before ordering, or send us a photo and we’ll check.

Replaces†

Brand Description
Culligan AC-series 50 GPD TFC membrane (TFM-50-A type)
Culligan Part numbers 01-0060-98 and 00-4015-33 (AC-series 50 GPD); compare size before ordering

Not compatible with

  • Culligan quick-change and sealed-cartridge systems (for example, twist-on canister membranes)
  • Standard under-sink RO systems (use MEM-1812-50-U)
  • Watts Premier, Kenmore, Whirlpool and RainSoft systems (see the table above)

Check before you order: remove your old membrane and compare. It should be a loose membrane about 1.85″ wide and 12″ long, not a sealed canister. Not sure? Send us a photo of your system’s model label or your old membrane and we’ll confirm the fit.

Fit questions

Will it fit my Culligan AC-30?
Yes. It’s sold as the stage 3 replacement membrane for the AC-30 and AC-15.

Is it a genuine Culligan part?
No. It’s a compatible replacement made by PureT, at a much lower price than the dealer part.

Can I use it in a standard under-sink RO system?
We don’t recommend it. Standard systems should use a standard 1812 membrane such as MEM-1812-50-U.

My Culligan system is leased. Can I replace the membrane myself?
Check your lease or service agreement first. Some require dealer service.

Does it come with a flow restrictor?
No, the membrane only.

*Rated output, reduction ranges and compatibility are based on manufacturer and industry data; real-world output is usually lower than the rating.

†Culligan and Aqua-Cleer are trademarks of Culligan International Company. Watts, Kenmore, Whirlpool and RainSoft are trademarks of their respective owners. Brand names and part numbers are used only to identify compatible systems. My Water Club is not affiliated with or endorsed by any of these companies. This is a compatible replacement membrane, not an OEM part. Using a non-OEM part may affect your system manufacturer’s warranty or service agreement.

Additional information

Weight 0.5 lbs
Dimensions 12 × 2 × 2 in

Reviews

There are no reviews yet.

Be the first to review “Culligan AC-30 / AC-15 Compatible 50 GPD RO Membrane, 1.85″ × 12″ TFC (PureT TW30-CAC-50)”