Description
A 3/4 inch PVC ball valve with female NPT threads on both ends — a quick quarter-turn shut-off before and after your whole house filter, full port, rated to 145 PSI and suitable for potable water. Automatic quantity discounts start at 2.
What the 3/4″ ball valve does
This valve turns water on or off with a quarter turn of the handle. Handle in line with the pipe = open; handle across the pipe = closed, so you can see its position at a glance. Both ends are 3/4″ female NPT, so it threads onto any 3/4″ male NPT fitting — a union nipple, a pipe nipple, an adapter or threaded pipe.
The most common use is one valve before and one after a whole house filter system. Close both, release the pressure and you can change cartridges or service a housing without water coming back from the house side. Paired with our 3/4″ union nipple, it connects straight to the 3/4″ port of a filter housing.
Key benefits
- ✓3/4″ FNPT × 3/4″ FNPT — the same female thread on both ends
- ✓Quarter-turn T-handle — open or closed in one move, by hand
- ✓Full port — the ball opening matches the pipe size, so it doesn’t choke flow when open
- ✓Rated to 145 PSI — well above typical home water pressure (40–80 PSI)
- ✓Gray PVC body — no metal to rust, corrode or seize
- ✓Suitable for potable (drinking) water; made in Taiwan
- ✓The same valve we include with our 3/4″ port whole house systems
Specifications
Buy more, pay less
| Quantity | Price each |
|---|---|
| 1 | $2.49 |
| 2–4 | $2.29 |
| 5–9 | $1.99 |
| 10–19 | $1.79 |
| 20+ | $1.59 |
Discounts apply automatically in the cart.
Compatibility
- My Water Club whole house systems with 3/4″ ports — slim 10″ × 2.5″ and heavy-duty housings with 3/4″ ports
- Our 3/4″ union nipple (FT-UN-34B-R) and any 3/4″ male NPT nipple, adapter or pipe
- Cold-water lines: whole house filters, water softeners, irrigation, utility lines
- 1″ ports (heavy-duty housings with 1″ ports) or 1/2″ NPT
- Glue-on (socket / solvent-weld) PVC pipe — this valve is threaded
- Hot water, gas or compressed air
Often used with
Slim 10″ × 2.5″ parts → · Heavy-duty BB parts →
Good to know before you install
- Wrap the male threads, not the valve. Put 3–4 wraps of PTFE tape clockwise on the male pipe or nipple threads. If you use our O-ring union nipple, keep the tape off the O-ring.
- Don’t over-tighten. Thread hand-tight, then about one more turn with a wrench. Too much force can crack plastic female threads.
- Hold the valve body with a second wrench when tightening, so you don’t twist the fitting or the housing behind it.
- For cartridge changes: close both valves, then release the pressure (most housings have a red pressure-release button on the cap) before you unscrew the sump.
- Cold water only. Your system’s pressure limit is the lowest rating in it — usually the filter housing, not the valve.









Reviews
There are no reviews yet.