Description
A washable, reusable pleated sediment filter in heavy-duty 20″ × 4.5″ (BB) size: pleated polyester rated 5 micron that captures dirt, silt, sand and rust particles on the main water line — rinse it clean and reinstall instead of replacing it every time.
What this washable pleated sediment filter does
The SED5-PLT-20BB is a pleated sediment pre-filter for standard heavy-duty 20″ × 4.5″ housings. Its polyester fabric is folded into pleats, giving it much more filtering surface than a smooth-walled cartridge of the same size, so it can hold a lot of dirt, silt, sand and rust particles before it needs attention.
The main difference from a disposable cartridge: it’s washable and reusable. When flow starts to drop, pull the cartridge, rinse the pleats clean with a hose, and reinstall. On sediment-heavy water, where a disposable cartridge might clog in weeks, one pleated cartridge can go through a number of rinse cycles. Plan to replace it every 6–12 months, or sooner if the fabric is torn or flow stays low after rinsing.
The 20″ × 4.5″ format has about twice the pleated surface of the 10″ × 4.5″ version, which suits larger homes, wells and higher-use lines. Like every sediment stage, it runs first in line, catching grit before it reaches the carbon and specialty stages after it. It fits the same housings as other 20″ × 4.5″ pleated cartridges — see the compatibility list below.
Key benefits
- ✓ Washable & reusable — rinse and reinstall
- ✓ Pleated design gives more filtering surface than a smooth cartridge
- ✓ Captures dirt, silt, sand & rust particles at 5 µm nominal
- ✓ A good fit for sediment-heavy well water
- ✓ Large 20″ × 4.5″ body — about twice the pleated surface of a 10″ cartridge
- ✓ Replaces same-size pleated cartridges from Hydronix, US Water Systems, Watts & more*
Specifications
Helps reduce
What this cartridge targets — and what it isn’t built for.
Sand
Rust particles
Sediment particles
Chlorine / taste
Dissolved iron
Hardness / scale
Dissolved chemicals
Which 20″ × 4.5″ cartridge do I need?
The MyWaterClub heavy-duty 20″ × 4.5″ range by stage. Your current filter is highlighted — tap any other name to view it.
Browse all 20″ × 4.5″ BB cartridges →
Good to know before you buy
Pleated vs. melt-blown — pick by your sediment load. Pleated fabric catches particles on its surface, which is why it rinses clean and suits heavy, visible sediment (well water, older pipes, after main breaks). Melt-blown (SED5-20BB) traps particles through its depth — a better fit for city water with lighter, finer sediment, at the lowest cost per cartridge.
How to rinse. Shut off the water, relieve housing pressure, remove the cartridge, and rinse the pleats outside-in with a hose until the runoff is clear. A soft brush helps on stubborn buildup. Reinstall — no tools needed beyond the housing wrench. Step-by-step: SED5-PLT-20BB support page.
When to replace it. Reusable isn’t forever: each rinse leaves a little fine silt in the fabric. Replace it every 6–12 months, or sooner when the fabric is torn or deformed or flow stays low even after a thorough rinse.
20″ or 10″? Both are 4.5″ across; only the length differs, and they don’t swap. Measure your old cartridge or the housing sump before ordering. If your housing takes standard 20″ × 4.5″ (BB) cartridges — often called Big Blue® size — this is your size†.
Keep a spare and never wait on a wet filter. With two cartridges you swap in the clean one right away and rinse the dirty one when it suits you. Buying 2 or more lowers the price per cartridge. Local pickup in San Diego is free: choose Local Pickup at checkout and skip the shipping on these large cartridges.
Compatible housings & replacement cartridges
SED5-PLT-20BB is a standard 20″ × 4.5″ washable pleated sediment cartridge, rated 5 micron. It fits the housings below and can replace the same-size pleated cartridges listed after them.*
Housings & systems it fits
Replacement for Hydronix SPC-45-2005, US Water USWPF-4520-05, Watts WPC5FF20 & other 5-micron pleated cartridges
Switching from a coarser pleated or disposable sediment cartridge
These same-size cartridges fit the same housing but have a different micron rating or media — see the fit questions.
Also searched as: SPC452005 · USWPF452005 · WPC5FF20 · FMBB205 · SPF452005 · HB205W · PS4520005 · 25549443 · washable sediment filter 20×4.5 · pleated filter 4.5 x 20 5 micron · reusable big blue sediment filter 20 inch
Check before you order. Your old cartridge should be about 4.5″ across and 20″ long, with an open center hole at both ends. A 10″ cartridge will not seal in a 20″ housing. Not sure? Send us a photo of the cartridge label and we’ll confirm the fit.
Orange or rusty water? This stage catches rust particles; clear water that stains orange later has dissolved iron — add IRON-20BB after it.
Fit questions
Can I use SED5-PLT-20BB in place of the Pentek ECP5-20BB?
Yes. Both are 20″ × 4.5″ pleated cartridges rated 5 micron, so it fits the same Big Blue® #20 housings†. The ECP5-20BB uses a cellulose-polyester blend; SED5-PLT-20BB is polyester fabric, made to be rinsed and reused.
Will it replace the Hydronix SPC-45-2005 or US Water USWPF-4520-05?
Yes. They are also 20″ × 4.5″ polyester pleated cartridges rated 5 micron. Rinse and replace on the same routine you use now.
I have an iSpring WGB22B or WGB32B. Can I use it in Stage 1?
Yes. It fits the first (sediment) housing, where the FP25B goes. The FP25B is a disposable polypropylene cartridge; SED5-PLT-20BB is pleated and washable, which suits well water and other sediment-heavy supplies. Keep the carbon cartridges in the later stages.
How often should I rinse it?
When water pressure drops noticeably or the pleats look brown. On sediment-heavy well water that can be every few weeks; on city water, much less often. Replace it every 6–12 months, or sooner if the fabric tears or flow stays low after a thorough rinse.
I use a 20- or 30-micron pleated cartridge. Can I switch to 5 micron?
It fits the same housing. 5 micron catches finer particles, so it also loads up faster on very dirty water. If yours clogs quickly, keep a coarser cartridge in a housing ahead of it.
My housing is 10″ long. Will this fit?
No. This is the 20″ cartridge. For 10″ × 4.5″ housings, see our 10″ × 4.5″ cartridges.
Building a full stack?
† Big Blue® and Pentek® are registered trademarks of Pentair. My Water Club is not affiliated with, sponsored by or endorsed by Pentair. These names are used only to describe size and compatibility.
* 3M and Aqua-Pure, APEC, Brio, Express Water, Harmsco, Hydronix, iSpring, Liquatec, Neo-Pure, SimPure, SpiroPure, Tier1, US Water Systems, USWF, VIQUA and Watts, and their model names, are trademarks of their respective owners. My Water Club is not affiliated with, sponsored by or endorsed by these companies, and this cartridge is not made by them. Brand and model names are used only to identify housings this cartridge fits and the same-size cartridges it can replace. Compatibility is based on the standard 20″ × 4.5″ size; please check your housing before ordering.










Reviews
There are no reviews yet.