A push-to-connect 90° elbow that joins two lengths of 3/8″ OD tubing — both ends quick-connect, no thread, no tape. Redirects a 3/8″ tubing run around a corner without kinking. Sold as a 2-pack.

What it does

This tube-to-tube elbow connects 3/8″ OD tubing to 3/8″ OD tubing at a 90-degree angle. Both ends are push-to-connect. It redirects a tubing run cleanly without kink risk.

Unlike MNPT elbows (which have a threaded port side), this fitting is tube-on-both-ends — it goes inline between two sections of 3/8″ tubing. Use anywhere you need a 90° turn in a 3/8″ line.

Key benefits

• ✓3/8″ QC × 3/8″ QC — push-fit on both ends
• ✓90° elbow — clean direction change without kinking
• ✓No tape, no tools — O-ring sealed
• ✓Compact for tight routing under sinks and behind systems
• ✓Works with under-sink RO, inline filters & water filtration
• ✓2-pack with automatic quantity discounts

Specifications

Compatibility

Often used with

Good to know before you buy

• Cut tubing square before pushing into each port.
• Push fully in until it seats. Tug to confirm.
• O-ring sealed — no thread tape needed.
• Check both connections for leaks before pressurizing.