Description
This triple filter mounting bracket wall-mounts a 3-stage heavy-duty BB whole house system. The white powder-coated steel bracket carries the weight of three housings so your plumbing doesn’t have to, and it fits both 10″ and 20″ × 4.5″ housings with 1″ ports.
What the triple filter mounting bracket does
Three water-filled heavy-duty housings are heavy, too heavy to hang from the inlet and outlet pipes. Each housing cap screws to this 3-stage filter bracket, and the bracket screws to the wall, so the system stays put and your 1″ fittings and union nipples aren’t carrying the load.
The bracket also holds the three housings level and evenly spaced, in line with the union nipples between them, so cartridge changes are quick and nothing twists when you loosen a sump. The same whole house filter bracket works for 10″ and 20″ housings, because the bracket holds the caps and housing length doesn’t matter. It’s a good fit for garages, basements and utility rooms.
Key benefits
- ✓Heavy-duty powder-coated steel — sized for three water-filled heavy-duty housings
- ✓Fits 10″ and 20″ × 4.5″ housings — one bracket for either length
- ✓Keeps housings level and evenly spaced for easier cartridge changes
- ✓Takes the load off inlet/outlet plumbing and the 1″ union nipples
- ✓White powder-coat finish — clean look, resists corrosion indoors
- ✓Pre-drilled to match My Water Club heavy-duty BB housings
Specifications
Compatibility
- My Water Club heavy-duty 10″ × 4.5″ housings and 3-stage BB systems
- 10″ and 20″ × 4.5″ housings with 1″ ports
- Other brands’ heavy-duty housings — compare the cap’s screw-hole pattern and the spacing between housings before buying
- Slim 10″ × 2.5″ housings (use the slim triple bracket)
- 2-stage systems — use the heavy-duty dual bracket; 1-stage systems use the single bracket
- Outdoor or exposed locations
Often used with
Browse all heavy-duty BB parts → · 10″ × 4.5″ BB cartridges & sets →
Good to know before you buy
- Hardware is not included. Choose wall screws and anchors for your wall type (wood stud, masonry, etc.), and order the 5/16″ × 1″ housing screws separately.
- Mount into studs or solid backing. Three water-filled 10″ housings weigh roughly 40–60 lb, and 20″ housings weigh more. Drywall anchors alone loosen over time.
- Leave room below to drop the sumps: about 12″ under 10″ housings and 22″ under 20″ housings.
- Level the bracket before fully tightening it. A tilted bracket makes cartridge changes harder and stresses the plumbing.
- Indoor or protected locations only — not for outdoor exposure.
- Cutting into your main water line? If you’re not comfortable soldering or working with PEX, a plumber is recommended.
† Big Blue® is a registered trademark of Pentair. My Water Club is not affiliated with, sponsored by or endorsed by Pentair. The name is used only to describe size.




Reviews
There are no reviews yet.