My Water Club Product Support

Iron Reduction Filter — 10″ × 4.5″

IRON-10BB

Specifications, how to change it, which housings it fits, and what to pair it with.

My Water Club IRON-10BB iron reduction cartridge
Is this your filter?

Check the cartridge in your housing against this list.

  • ✓A large cartridge, about 4.5″ wide and 10″ long
  • ✓Filled with small resin beads
  • ✓Label reads IRON-10BB
  • ✓Sits after the sediment stage
Measure your housing before you order
  • About 4.5″ wide and 10″ tall, with 1″ ports: this cartridge fits.
  • Narrow, about 2.5″ wide with 3/4″ ports: you need a 10″ × 2.5″ cartridge. Find your model →
  • About 4.5″ wide and 20″ tall: you need a 20″ × 4.5″ cartridge. Ask us →

Specifications

Model / SKU IRON-10BB
Media Iron-reduction / softening cation-exchange resin
Rating 25 micron (nominal)
Size Standard 10″ × 4.5″ heavy-duty whole-house housings
Position Specialty stage — after sediment (after carbon on chlorinated water)
Pressure Max 90 PSI · above 80 PSI, fit a pressure regulator
Temperature 40–100 °F (4–38 °C), cold water only
Typical life 2–6 months
Brand My Water Club

Reorder this filter

Order the same cartridge

Order by SKU IRON-10BB.

View on MyWaterClub.com →

Buy on Amazon →
Other option
CATKDF85-10BB — Catalytic carbon + KDF-85

Iron with a rotten-egg smell? KDF-85 helps reduce H₂S odor. Send us your water test and we’ll tell you which to put first.

Support page →  ·  View on MyWaterClub.com →

My Water Club systems that use this filter

It isn’t standard in any system. Add it as an extra stage with a HOUSING10BB housing, after sediment (and after carbon on chlorinated water). It also fits other standard 10″ × 4.5″ housings, including our HOUSING10BB.

Good to know

  • For clear-water (dissolved) iron only. Fill a glass: if it comes out clear and turns orange as it sits, this is the right cartridge. If it comes out red or rusty, the iron has already oxidized and needs different treatment.
  • On chlorinated city water, put carbon first. Chlorine wears out the resin. Run GAC-10BB or CTO-10BB ahead of it.
  • Hardness shares the capacity. The resin also takes up hardness minerals, so on hard water it fills faster and iron reduction drops sooner. Change it when staining returns, even if that’s before the calendar says so.

When to change your filter

Part Typical interval Change sooner if…
This cartridge (IRON-10BB) 2–6 months Orange staining or metallic taste returns · hard water · higher iron levels
Housing O-ring Inspect at every change · replace every 12–24 months Cracked, flattened, brittle or weeping at the seam (O-ring sets)
Filter housing About every 3–4 years Crazing, hairline cracks, cloudiness, or a leak a new O-ring doesn’t stop (HOUSING10BB)

Intervals are estimates. Water chemistry, pressure and usage all change them.

Changing your filter

  1. Shut off the water: close the valves on both sides of the system (or the bypass), or the main shut-off.
  2. Open a cold tap downstream, then press the pressure release button on the cap until the hissing stops.
  3. Put a bucket and towels underneath — a 10″ × 4.5″ housing holds over a gallon of water.
  4. Unscrew the sump with the housing wrench (counterclockwise, looking up from below), supporting its weight.
  5. Remove the old cartridge and rinse the sump with clean water only — no soap or bleach.
  6. Inspect the O-ring and replace it if it’s damaged. Coat it lightly with food-grade silicone grease (never petroleum jelly).
  7. Unwrap the new cartridge and stand it centered on the post in the sump.
  8. Screw the sump on by hand, then snug it with the wrench — no more than a quarter turn. Don’t overtighten.
  9. Turn the water back on slowly. Press the release button to let air out, and check for leaks now and again after 12 hours.
  10. Run a cold tap for 2–3 minutes to flush the new cartridge.
  11. Write the change date on the housing, a magnet or the manual.

What to put before and after it

Put a sediment stage in front of it. On chlorinated water, put a carbon stage in front as well — chlorine wears out the resin. On hard water, a scale inhibitor can go last.

Position Cartridge Good for What it does
Before it SED5-10BB Stage 1 on most water 5 µm melt-blown polypropylene · captures dirt, silt, sand & rust particles
Before it SED5-PLT-10BB Heavy sediment, well water 5 µm pleated polyester · rinse and reuse
Before it GAC-10BB City water · lowest cost carbon Granular carbon for chlorine, taste, odor & VOCs at full flow
Before it CTO-10BB Everyday city water Carbon block, 10 µm · reduces chlorine, taste & odor · lowest cost block
After it SCALE-10BB Limescale Polyphosphate helps prevent scale in pipes & appliances · not a softener

Browse all 10″ × 4.5″ cartridges → · Free basic water testing in San Diego →

Common questions

  1. My water comes out orange or rusty.
    That iron has already oxidized, and this cartridge can’t treat it. Orange water needs a backwashing iron system — ask us.
  2. Orange staining came back after a few weeks.
    On hard water the hardness uses up the resin’s capacity, so iron reduction drops sooner. Change the cartridge when staining returns.
  3. Is this a water softener?
    No. It reduces some hardness, but its capacity is small compared with a whole-house softener.
  4. Where does it go on chlorinated city water?
    After a carbon stage. Chlorine wears out the resin.
  5. There’s a leak where the housing meets the cap.
    The O-ring isn’t seated, or it’s worn. Shut off the water, press the release button, then reseat or replace the O-ring and coat it lightly with food-grade silicone grease.
  6. The housing won’t unscrew.
    Usually there’s still pressure inside, or it was overtightened. Make sure the water is off, press the release button, then use the housing wrench.

Need help?

Contact us
Send a photo of your cartridge or housing and we’ll identify it.

Get in touch →

All manuals
Instructions for every My Water Club system.

Browse manuals →

San Diego area service
In-person help and free basic water testing.

Local service →

Warranty & returns
What’s covered and how to start a return.

View policy →

Call or text (858) 345-7345. Bought on Amazon? You can also use Your Orders › Contact seller.

Scope and disclaimers

This cartridge treats the contaminants named on this page only. It doesn’t make unsafe water safe to drink. Treat untested well water, or water under a boil-water advisory, before relying on any filter.

Filter life and reduction performance depend on your water chemistry, pressure and usage, so results vary from home to home. Intervals on this page are typical estimates, not guarantees. Our filters are not certified to treat water of unknown quality and are not a substitute for testing your water. Descriptions use general, qualified language and are not health claims.