Description
A washable, reusable pleated sediment filter in heavy-duty 10″ × 4.5″ (BB) size: pleated polyester rated 5 micron that captures dirt, silt, sand, and rust — rinse it clean and reinstall instead of replacing it.
What this washable pleated sediment filter does
The SED5-PLT-10BB is a pleated sediment pre-filter for standard heavy-duty 10″ × 4.5″ housings. Its polyester fabric is folded into pleats, giving it much more filtering surface than a smooth-walled cartridge of the same size, so it can hold a lot of dirt, silt, sand, and rust particles before it needs attention.
The main difference from a disposable cartridge: it’s washable and reusable. When flow starts to drop, pull the cartridge, rinse the pleats clean with a hose, and reinstall. On sediment-heavy water, where a disposable cartridge might clog in weeks, one pleated cartridge can go through a number of rinse cycles. Replace it when the fabric is torn or flow stays low after rinsing.
Like every sediment stage, it runs first in line, catching grit before it reaches the carbon and specialty stages after it. It fits the same housings as other 10″ × 4.5″ pleated cartridges — see the compatibility list below.
Key benefits
- ✓ Washable & reusable — rinse and reinstall
- ✓ Pleated design gives more filtering surface than a smooth cartridge
- ✓ Captures dirt, silt, sand & rust particles at 5 µm nominal
- ✓ A good fit for sediment-heavy well water
- ✓ Replaces same-size pleated cartridges from Hydronix, US Water Systems, Watts & more*
- ✓ Fits all My Water Club 10″ × 4.5″ systems & HOUSING10BB
Specifications
Helps reduce
What this cartridge targets — and what it isn’t built for.
Sand
Rust particles
Sediment particles
Chlorine / taste
Dissolved iron / H₂S
Hardness / scale
Bacteria & cysts
Which 10″ × 4.5″ cartridge do I need?
The MyWaterClub heavy-duty 10″ × 4.5″ range by stage. Your current filter is highlighted — tap any other name to view it.
Browse all 10″ × 4.5″ BB cartridges & sets → · Specialty media →
Good to know before you buy
Pleated vs. melt-blown — pick by your sediment load. Pleated fabric catches particles on its surface, which is why it rinses clean and suits heavy, visible sediment (well water, older pipes). Melt-blown (SED5-10BB) traps particles through its depth — a better fit for city water with lighter, finer sediment, at the lowest cost per cartridge.
How to rinse. Shut off the water, relieve housing pressure, remove the cartridge, and rinse the pleats outside-in with a hose until the runoff is clear. A soft brush helps on stubborn buildup. Reinstall — no tools needed beyond the housing wrench.
When to replace it. Reusable isn’t forever: each rinse leaves a little fine silt in the fabric. Replace it when the fabric is torn or deformed, or when flow stays low even after a thorough rinse.
Compatible housings & replacement cartridges
SED5-PLT-10BB is a standard 10″ × 4.5″ washable pleated sediment cartridge, rated 5 micron. It fits the housings below and can replace the same-size pleated cartridges listed after them.*
Housings & systems it fits
Replacement for Hydronix SPC-45-1005, US Water USWPF-4510-05 & other 5-micron pleated cartridges
Switching from a coarser pleated or disposable sediment cartridge
These same-size cartridges fit the same housing but have a different micron rating or media — see the fit questions.
Also searched as: SPC451005 · USWPF451005 · WPC5FF975 · FF10BBP5 · washable sediment filter 10×4.5 · pleated filter 4.5 x 10 5 micron · reusable big blue sediment filter 10 inch
Check before you order. Your old cartridge should be about 4.5″ across and 9¾–10″ long, with an open center hole at both ends. Not sure? Send us a photo of the cartridge label and we’ll confirm the fit.
Orange or rusty water? This stage catches rust particles; clear water that stains orange later has dissolved iron — add IRON-10BB after it.
Fit questions
Can I use SED5-PLT-10BB in place of the Pentek ECP5-BB?
Yes. Both are 10″ × 4.5″ pleated cartridges rated 5 micron, so it fits the same housing. The ECP5-BB uses a cellulose-polyester blend; SED5-PLT-10BB is polyester, made to be rinsed and reused.
Will it replace the Hydronix SPC-45-1005 or US Water USWPF-4510-05?
Yes. They are also 10″ × 4.5″ washable polyester pleated cartridges rated 5 micron. Rinse and replace on the same routine you use now.
I have an iSpring WGB21B or WGB31B. Can I use it in Stage 1?
Yes. It fits where the FP15B goes. The FP15B is a disposable polypropylene cartridge; SED5-PLT-10BB is pleated and washable, which suits well water and other sediment-heavy supplies.
How often should I rinse it?
When water pressure drops noticeably or the pleats look brown. On sediment-heavy well water that can be every few weeks; on city water, much less often. Replace it when the fabric tears or flow stays low after a thorough rinse.
I use a 30-micron pleated cartridge. Can I switch to 5 micron?
It fits the same housing. 5 micron catches finer particles, so it also loads up faster on very dirty water. If yours clogs quickly, keep a coarser cartridge in a housing ahead of it.
Building a full stack?
† Big Blue® and Pentek® are registered trademarks of Pentair. My Water Club is not affiliated with, sponsored by or endorsed by Pentair. These names are used only to describe size and compatibility.
* American Plumber, APEC, Culligan, Express Water, Filters Fast, GE, Hydronix, iSpring, 3M and Aqua-Pure, US Water Systems, USWF, Watts and WECO, and their model names, are trademarks of their respective owners. My Water Club is not affiliated with, sponsored by or endorsed by these companies, and this cartridge is not made by them. Brand and model names are used only to identify housings this cartridge fits and the same-size cartridges it can replace. Compatibility is based on the standard 10″ × 4.5″ size; please check your housing before ordering.












Reviews
There are no reviews yet.